call us on: +86-571-86059127  E-mail: uking@ukingadhesive.com  
Uking Industrial Co.,Ltd
Tel: +86-571-86059127
E-mail: uking@ukingadhesive.com
Product Categories
News
Home > News > Content

Tile Adhesive Scratch Thickness

Edit:Uking Industrial Co.,Ltd   Date:Sep 29, 2017

Tile Adhesive Scratch thickness

The thickness of the tile binder is determined by its own material properties. Since the ceramic tile has good water retention and the drying rate is relatively slow, the expansion and contraction ratio of the material itself is too thick Also increased, which led to the adhesive layer and the tile, the wall between the three expansion coefficient of contraction does not match the interface to reduce the strength of bonding, most likely the emergence of the whole piece of peel off the brick!

What is a thin sticker

Thin paste the concept of the earliest founded in Germany, is the domestic hot in recent years, rising the new paste tile process. Thin paste with a professional tile adhesive and tooth type scraper, in the construction of the first layer of the first tile adhesive comb into a striped. And then in order to tile the way to puzzle on the paste in the clay, the use of kneading, squeezing, compaction, positioning of the dry work paste method. The construction process only need to add water, no bubble, than the traditional cement mortar construction efficiency greatly improved, and effectively solve the hollowing, out of brick and other issues, by the major brands in the same sought after.

Why tile adhesive can not be thick paste

The thickness of the tile binder is determined by its own material properties. Since the ceramic tile has good water retention and the drying rate is relatively slow, the expansion and contraction ratio of the material itself is too thick Also increased, which led to the adhesive layer and the tile, the wall between the three expansion coefficient of contraction does not match the interface to reduce the strength of bonding, most likely the emergence of the whole piece of peel off the brick!

Therefore, if the use of tile adhesive paving tiles occurred in the whole piece of stripping the tragedy, most likely the adhesive layer was too thick.

【solution】

In the vertical formation of the premise of the wall, usually tile adhesive as long as 0.5cm within the thickness, you can play the biggest advantage. If the wall is not vertical, the paste layer is too thick to reach more than 2cm, you must first use the cement to flatten the wall so that the vertical formation, dry before using the tile adhesive to paste. And the higher the vertical and flatness of the base surface, the less the amount of tile binder, the more cost savings.

Construction Technology of Tile Adhesive

1: If you paint or the old wall before the refurbished surface only need to use short hair roller roll can be.

2: paste the tile before: half an hour in advance, with a brown brush or a small roller to stir the binder evenly, brush directly on the back of the tile (brick around the edge can stay 5mm or so, to prevent the adhesive flow to the front) After its surface is transparent, add about one-third of the cement with sand and stir into the mortar. Paste the wall is also recommended to brush again tile adhesive, so sticky stronger, better waterproof, absolutely not hollow, do not fall off.

3: Material consumption: This product does not need to add water, open the barrel directly after use, single coated layer, per kilogram of binder can brush 10-13 square meters.

4: the best construction temperature of 5 ℃, the actual brushing area will be due to construction methods, surface smoothness and construction environment are different.


Contact Us
Address:5# Building ShenXin Square, 2888 # Jiu Xin Road, Songjiang District, Shanghai City
Tel: +86-571-86059127  Fax:86-571-86059127
E-mail:uking@ukingadhesive.com
Copyright © Uking Industrial Co.,Ltd