call us on: +86-571-86059127  E-mail: uking@ukingadhesive.com  
Uking Industrial Co.,Ltd
Tel: +86-571-86059127
E-mail: uking@ukingadhesive.com
Product Categories
News
Home > News > Content

Tile Adhesive Basic Performance

Edit:Uking Industrial Co.,Ltd   Date:Nov 02, 2017

Tile Adhesive Basic performance

In the general renovation process, can not help but encounter a variety of problems, as an experienced mason master, paste the tiles of this link is essential to a process. Part of the tile is not only depends on the skills of the master mud, the tile is good or bad, the most critical part, that is, ultimately, choose to add tiles accessories. How to make the tile on the wall is not hollowed out, do not fall off, as a basic tile tiling process.

  R & D of the senior tile adhesive, can effectively prevent the tiles off and empty drums. The following is a brief introduction to the basic properties of ceramic tile adhesive.

Tile binder, is a modern decoration of the new material, replacing the traditional tile glue. It is a liquid type of ceramic tile, also known as tile adhesive, tile adhesive. To solve the traditional tile adhesive paste will appear tiles hollowing off the phenomenon, and its low construction costs, construction and simple. Its characteristics include: high bonding strength, liquid type, freeze-thaw resistance, anti-aging, good performance, non-toxic environmental protection, construction convenience, is a very good bonding material. The following describes the use of ceramic tile adhesive.

1: If you paint or the old wall before the refurbished surface only need to use short hair roller roll can be.

2: paste the tile: 2 hours ahead of time, with a brown brush or a small roller to stir the binder evenly, brush directly on the back of the tile (brick around the edge can stay 2mm or so, to prevent the adhesive flow to the front), etc. The surface of the transparent, with ordinary cement to join about one-third of the sand into the mortar paste. Paste the wall is also recommended to brush again strong senior tile adhesive, so sticky stronger, better waterproof, absolutely no hollow, do not fall off.

Precautions:

1. This product does not need to add water, open the barrel directly after use, single coated layer, per kilogram of strong adhesive can be painted 10-13 square meters.

2. Read the instructions before use, this product should not be mixed with other brands of products

3. Construction should wear a mask, such as accidentally into the eye, should be promptly rinse with water. After the construction should immediately use the tap water cleaning tool, with the lid should be tightly sealed to save, to prevent the product contamination of dust and dirt, so that deterioration, shorten the storage life.

4. Construction process to pay attention to the brush of the binder of the brick, can only be stacked up on the back side of the stack (with small pieces of wood bedding), can not stand or vertical release, or else brush on the brick adhesive Flow of a place, that is, waste, but also affect the scene of the clean management, but also affect the construction effect. Tile binder, is a modern decoration of the new material, replacing the traditional tile glue. It is a liquid type of ceramic tile, also known as tile adhesive, tile adhesive. To solve the traditional tile adhesive paste will appear tiles hollowing off the phenomenon, and its low construction costs, construction and simple.


Contact Us
Address:5# Building ShenXin Square, 2888 # Jiu Xin Road, Songjiang District, Shanghai City
Tel: +86-571-86059127  Fax:86-571-86059127
E-mail:uking@ukingadhesive.com
Copyright © Uking Industrial Co.,Ltd